NonStop S-Series Hardware Installation and FastPath Guide (G06.25+)

HP NonStop S-Series Hardware Installation and FastPath Guide—529443-001
4
9. Performing Post-Startup Tasks
Powering On the System 8-6
Fault Tolerance and Access to Power Cutoffs 8-6
Power-On Procedure Using AC Power Cords 8-6
Status LEDs During a Power-On Procedure 8-10
Troubleshooting Abnormal LED States 8-12
Verifying Topology and System Components 8-14
Starting the System 8-17
Loading the System 8-17
Completing the System Load 8-20
Verifying the System Is Started 8-20
9. Performing Post-Startup Tasks
Testing the System 9-1
Check Power Supplies 9-2
Check System Enclosure Components 9-2
Check Critical System Processes 9-6
Check Disk Subsystem Status 9-7
Test the Disk Drives 9-8
Test the Communications Lines 9-10
Check Tape Subsystem Status 9-10
Test the Tape Subsystems 9-11
Completing Final Installation Steps 9-12
System Configuration Changes and Verifications 9-13
Restarting the Inspect Monitor Process 9-14
Preparing for Daily Operations 9-15
Reference Manuals 9-15
Configuring the OSM or TSM Environment 9-16
Configuring the OSM Environment 9-16
Configuring the TSM Environment 9-16
10. Configuring the System
Setup Configuration 10-2
Procedure to Create the Setup Configuration 10-2
Operating Configuration 10-3
Create the Operating Configuration 10-4
Add a System Console to the Operating Configuration 10-7
Add a Server to the Operating Configuration 10-9
Create a Cascading Ethernet Switch Configuration 10-11
Add a System Console to the Cascading Ethernet Switches 10-13
Add a Server to the Cascading Ethernet Switches 10-13