NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

Installing External System Devices
HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001
7-6
Installing a 5175 Open-Reel Tape Subsystem
8. Install the pedestal top panel and corner caps as shown in Figure 7-4:
a. Position the pedestal top panel (packed separately) on top of the 5175 module,
aligning the edges.
b. Position a red corner cap (packed separately) at each corner of the top panel,
aligning the edges with the pedestal frame. Push down firmly to secure each
cap. The four caps hold the top panel in place. Each cap fastens to the frame
with a push/pull fastener.
9. Locate the tape subsystem SCSI cable, which is packed separately. For cable
lengths and their corresponding part numbers, see the CSSI Web. See CSSI Web
on page xxiii.
10. Connect the SCSI cable to the tape subsystem:
a. Open the back panel of the 5175 module.
b. Find the uncapped SCSI port at the rear of the tape drive CRU.
Figure 7-4. Installing the Top Panel and Corner Caps on a 5175 Tape Subsystem
Top Panel
VST557.vsd
Red Corner Cap
(4 places)