NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

About This Guide
HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001
xxii
What’s in This Guide
7 Installing External System
Devices
This section describes how to install selected
peripheral devices such as tape subsystems.
8
Powering On and Starting
the System
This section describes how to power on NonStop
S-series system enclosures, how to power on
external devices, and how to start the system.
9
Performing Post-Startup
Tasks
This section describes the tasks that you must
perform after the NonStop S-series server has been
powered up and started.
10
Configuring the System This section describes how to configure system
consoles and NonStop S-series servers in several
ways.
11
Offline Configuration
Tasks
This section describes offline configuration tasks,
which change software or hardware configurations
and require the system to be shut down.
12
Online Configuration
Tasks
This section describes how to configure your system
online using the Subsystem Control Facility (SCF),
Kernel-Managed Swap Facility (KMSF), OSM, and
TSM, and how to create an alternate $SYSTEM disk.
13
Creating Startup and
Shutdown Files
This section describes command files that
automatically start and shut down a NonStop
S-series server.
14
Case Study: Installing and
Configuring a System
This section documents the installation and
configuration of a NonStop S7000 system for a
fictitious company.
A
Part Numbers Part numbers have been moved to the CSSI Web.
B
ServerNet Cabling This appendix contains ServerNet cabling diagrams
and tables for maximum Tetra 8 and Tetra 16
configurations. It also contains diagrams and tables
for selected smaller configurations.
C
Power-On Cabling This section provides power-on cabling diagrams for
selected large and smaller ServerNet configurations.
D
Troubleshooting This appendix explains basic recovery tasks for the
system and system console.
E
FastPath Tasks: Required This appendix contains all the tasks required to
install, start, and configure a two-processor or four-
processor NonStop S-series server in the Tetra 8
topology.
F
FastPath Tasks: Optional This appendix contains all optional configuration
tasks for a two-processor or four-processor NonStop
S-series server in the Tetra 8 topology.
Glossary
The Glossary lists terms and abbreviations used in
this text.
Section Title Contents (page2of2)