NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

Creating Startup and Shutdown Files

HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001

13-5

Example Command Files

This section describes and shows examples of command files that can be used to start

up and shut down the server:

•

Examples and sample programs are for illustration only and might not be suited for

your particular purpose.

HP does not warrant, guarantee, or make any representations regarding the use or

the results of the use of any examples or sample programs in any documentation.

You must verify the applicability of any example or sample program before placing

the software into production use.

•

These examples are for a system whose configuration has been changed from the

factory-installed configuration. Your system’s initial configuration will differ from

these examples.

•

The examples in this section are based on the examples in Appendix 14, Case

Study: Installing and Configuring a System.

The startup files in this section assume that the objects they start have already

been added to the configuration database for the system. For examples of files that

add these objects to the configuration database, see Appendix 14, Case Study:

Installing and Configuring a System.

•

The IP addresses used in this section are examples only. If you use the example

files described in this section on your system, you must change the IP addresses

in these examples to IP addresses that are appropriate for your LAN environment.

•

The configuration track-ID for the SWAN concentrator used in the example files,

X001XX, is also an example.

If you use the example files described in this section on your system, you must

change the configuration track-ID used in these examples to the actual

configuration track-ID assigned to your SWAN concentrator.