NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

Glossary
HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001
Glossary-93
save file
save file. A file created by the Inspect subsystem in response to a command from a
debugger. A save file contains enough information about a running process at a given
time to restart the process at the same point in its execution. A save file contains an
image of the process, data for the process, and the status of the process at the time
the save file was created.
A save file can be created through an Inspect SAVE command at any time. A save file
called a saveabend file can be created when a process’s SAVEABEND attribute is set
and the process terminates abnormally. Other debuggers can create a save file but
refer to the result as a process snapshot file. See also process snapshot file.
saveabend file. A file containing dump information needed by the system debugging tool.
(In UNIX systems, such files are usually called core files or core dump files.) A
saveabend file is a special case of a save file. See also save file and process snapshot
file.
saved-set group ID. An Open System Services (OSS) process attribute that stores a group
ID so that the group ID can later be used as the effective group ID of the process.
saved-set user ID. An Open System Services (OSS) process attribute that stores a user ID
so that the user ID can later be used as the effective user ID of the process.
save file. A file created by the Inspect subsystem in response to a command from a
debugger. A save file contains enough information about a running process at a given
time to restart the process at the same point in its execution. A save file contains an
image of the process, data for the process, and the status of the process at the time
the save file was created.
A save file can be created through an Inspect SAVE command at any time. A save file
called a saveabend file can be created when a process’s SAVEABEND attribute is set
and the process terminates abnormally. Other debuggers can create a save file but
refer to the result as a process snapshot file. See also process snapshot file.
SBB. See ServerNet buffer board (SBB)
.
SBI. See ServerNet bus interface (SBI)
.
SC. See Subscriber Channel (SC).
scalar view of the user ID. A view of the HP NonStop™ operating system user ID,
normally used in the Open System Services (OSS) environment, that is the value
(group-number * 256) + user-number. Also called the UID.
SCC. See serial communications controller (SCC).
SCF. See Subsystem Control Facility (SCF).
SCL. The mnemonic subsystem name for the ServerNet cluster subsystem.
SCP. See Subsystem Control Point (SCP).