NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

Introduction
HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001
1-36
Installation Overview
This figure shows the LCD of a ServerNet switch board. Two lines are displayed at a
time. You can use the scroll buttons to move up and down through the display.
ServerNet Cabling
This subsection describes ServerNet configurations, cables, connections, and routing.
Review this information before connecting ServerNet cables.
System Size
For More Information About See
Any of this information NonStop S-Series Planning and Configuration Guide
Table 1-3. Maximum Numbers of Enclosures for G06.03 and Later RVUs
Topology
NonStop S700
Server NonStop S7x00 Server NonStop Sxx000 Server
Tetra 8 1 processor enclosure
2 I/O enclosures
4 processor enclosures
8 I/O enclosures
4 processor enclosures
8 I/O enclosures
IOAM enclosures can
replace any or all I/O
enclosures attached to
group 01*
Tetra 16 N.A. 8 processor enclosures
16 I/O enclosures
8 processor enclosures
36 I/O enclosures
IOAM enclosures can
replace any or all I/O
enclosures attached to
group 01*
*For important restrictions on IOAM enclosures, see IOAM Configuration Requirements on page 1-32.
ServerNet Switch Board
LCD
NEWHP-G013-M02
Rack: OSM2 - 14
VST053.vsd