NonStop S-Series Hardware Installation and FastPath Guide (G06.26+)

Introduction
HP NonStop S-Series Hardware Installation and FastPath Guide—529876-001
1-43
Installation Overview
For more information about labeling, see the NonStop S-Series Planning and
Configuration Guide.
Cable Routing
To route ServerNet cables across enclosures:
1. Route them straight down.
2. Secure them to a cable support.
3. Direct them into cable channels.
•
Secure a cable to the cable support below the CRU to which the cable connects.
Secure the cable so that if you remove that CRU, you do not disrupt other cables.
•
Secure cables to the anchors on the cable supports. Secure ServerNet cables to
the outer cable support, and Ethernet or power-on cables to the inner one.
•
In a double-high stack, use only the base enclosure cable channels.
•
Guideposts guide cables from a stackable enclosure into the cable channels of a
base enclosure.
•
Guideposts on base enclosures are not often used, but you can route cables
underneath these guideposts to use up extra cable length.
Figure 1-20. ServerNet Cable Labeling
Caution. Do not pass cables or cords through the handles of CRUs or FRUs. The cables or
cords might become accidentally unplugged during later procedures. See Figure 1-21 for
proper cabling.
VST823.vsd
SEB 015105
IOMF 1150
S
E
B
0
1
5
1
0
5
I
O
M
F
1
1
5
0
S
E
B
0
1
5
1
0
5
I
O
M
F
1
1
5
0
SEB 015105
IOMF 1150