NonStop S-Series Hardware Installation and FastPath Guide (G06.27+)

Contents
HP NonStop S-Series Hardware Installation and FastPath Guide—540460-001
x
D. Troubleshooting (continued)
D. Troubleshooting (continued)
Multifunction I/O Board (MFIOB) Test Fails D-15
Dumping Processor Memory D-16
Dumping Processor Memory to Disk Online D-16
Dumping Processor Memory to Tape Offline D-20
Expand-Over-IP Connections D-22
Recovery Actions for the CONNECTING State D-24
Recovery Actions for the WAIT State D-24
Backing Out a Software Revision D-26
Prerequisites D-26
1. Start DSM/SCM D-26
2. Start and Log On to Target Interface D-27
3. Initiate Backout Activity D-27
4. Monitor Backout Process D-28
5. Stop All Applications D-28
6. Rename Software Files Using ZPHIRNM D-29
7. Stop System D-29
8. Load System From Saved Configuration D-30
9. Start Applications D-30
System Consoles D-31
Software Configuration Problems D-36
Software Corruption and Hard-Disk Problems D-37
Restoring Software on the Hard Disk D-38
Configuring a ProCurve 24-Port Ethernet Switch D-48
E. FastPath Tasks: Required
1. Install Hardware E-3
1. Inventory Shipment E-4
2. Collect Tools E-6
3. Unpack and Unload Server E-6
4. Connect Groundstraps E-10
5. Inventory and Inspect All Components E-11
6. Connect the Power-On Cables E-11
7. Connect Emergency Power-Off (EPO) Cables E-13
8. Connect ServerNet Cables E-14
9. Install Service-Side Enclosure Doors If Necessary E-15
10. Install Primary System Console E-16
11. Create Emergency Repair Disk or Automated System Recovery Disk E-18
12. Install Ethernet Switch E-18