NonStop S-Series Hardware Installation and FastPath Guide (G06.27+)

ManualsBrandsHP ManualsServerHP NonStop G-Series

231

232

233

234

235

236

237

238

239

240

Online Configuration Tasks

HP NonStop S-Series Hardware Installation and FastPath Guide—540460-001

12-15

7. Verify the Installation of Boot Millicode on the

Targ et Disk

7. Verify the Installation of Boot Millicode on the Target Disk

Use the SCF INFO, LABEL command to verify that the boot millicode was installed

correctly.

In this example, section 12 (Boot-LSA) shows that the address and length values are

now nonzero values.

14-> info $data08, label

STORAGE - Label Information DISK \WAGER.$DATA08

Disk Label Information $DATA08 Primary:

*Volume Name.......................... $SYSTEM

*Alternate Volume Name................ $DATA08

Volume ID............................ 20

Volume Label Verifier................ D2

Volume Label Version................. 0

Operating System Last Mounted Under.. F40 (P40)

Volume Label Last Written............ 02 Apr 1997, 16:41:45.006

Disk Subtype......................... 42

Section Name Address Length Version Parameter

-------------------- ------------- ------------- ------- -------------

0. Spare Tracks Table 000000.003000 000000.005000 0 000000.000000

1. Boot 000000.030000 000000.020000 0 000000.000000

2. Free Space Table 000000.010000 000000.020000 0 000000.000000

3. Directory Label 000000.110000 000000.010000 0 000000.000000

4. Unused 000000.000000 000000.000000 0 000000.000000

5. Undo 000000.120000 000000.020000 0 000000.000000

6. Pool 000000.000000 000000.000000 0 000000.000000

10. Pool-LSA 000000.000010 000407.061554 3 000000.000000

11. Free Space Table-LSA 000000.000010 000000.000020 3 000000.000000

12. Boot-LSA 000000.000030 000000.000020 0 000000.000000

Disk Label Information $DATA08 Mirror: