NonStop S-Series Hardware Installation and FastPath Guide (G06.27+)

Troubleshooting
HP NonStop S-Series Hardware Installation and FastPath Guide—540460-001
D-23
Expand-Over-IP Connections
PASSIVE If the Expand-over-IP line-handler process is
configured to issue passive connect requests,
this state indicates that the line-handler process
is waiting for the remote Expand-over-IP
line-handler process to initiate a connection.
If the Expand-over-IP line-handler process is
configured to issue active connect requests, this
state indicates that the reconnect limit has been
reached and that the line-handler process has
been configured to subsequently issue passive
connect requests.
This state is normal.
No recovery action is
required.
QUERY A connection has been established with the
remote Expand-over-IP line-handler process,
but no data has been received within the
inactivity interval. The Expand-over-IP
line-handler process is sending Probe
messages to the remote Expand-over-IP
line-handler process to verify that it is
operational.
If the line remains in
this state, the remote
(destination)
Expand-over-IP
line-handler process is
down or there is a
network problem.
SOCKET WAIT The Expand-over-IP line-handler process is
waiting for a User Datagram Protocol (UDP)
socket to be created.
This state is normal while the line is coming up.
If the line remains in this state, an internal error
might have occurred.
If the line remains in
this state, contact your
service provider.
WAIT The Expand-over-IP line-handler process is
waiting for another process or subsystem.
The line remains started, but it is not ready for
data transfer.
See the Detailed Info
field of the SCF
STATUS LINE display
for more specific error
information.
Recovering from these
types of problems is
described further on
D-24
.
Table D-1. Troubleshooting the Expand Connection Procedure (page2of2)
Detailed State Cause and Effect Recovery