NonStop S-Series Hardware Installation and FastPath Guide (G06.27+)

Safety and Compliance
HP NonStop S-Series Hardware Installation and FastPath Guide—540460-001
Statements-7
Consumer Safety Statements
Consumer Safety Statements
The following safety statements are specific for HP NonStop S-series servers.
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and
servicing of equipment described in this manual.
•
Keep door closed for normal operation.
•
The equipment must be installed near the receptacles for the power cords, and the
receptacles must be easily accessible to the user.
Applicability of Procedures, Instructions, and Examples
WARNING. Do not touch the DC power connector on the NonStop S7400, S7600, or Sxx000
PMF CRU after you have unplugged the DC power cable from the CRU. It is possible to incur a
severe energy hazard for as long as fifteen (15) seconds after unplugging the cable. You can
make sure the CRU is safe to remove by testing (by using a volt meter) before touching the
pins on the DC power connector.
WARNING. The procedures and instructions and the examples of procedures and instructions
found in this manual apply only to the system enclosures and components found in NonStop
S-series servers which are described in the NonStop S-series server documentation. Do not
attempt to use these instructions with any other NonStop system equipment. You can
determine that your system is a NonStop S-series server by reading the label that appears
inside each system enclosure on the CRU in slot 50 or 55. The label includes the product
number, 195x, 196x, 197x, or 198x. Read the label before proceeding with any procedure or
instruction found in this manual.