NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
2-12
Unpack the Enclosures
16. With a 3/4-inch (19-mm) or a 9/16-inch (15-mm) open-end wrench, lower the four
legs on the base enclosure:
a. Start with the enclosure leg raised. Use an open-ended wrench to loosen and
lower the leg. The size of the wrench depends on the leveling pads.
b. Use the wrench to tighten the leg against the floor.
17. Repeat Step 3 through Step 16 for any additional system enclosures.
Figure 2-9. Lowering Legs of Base Enclosure
Caster
Caster
VST017.vsd