NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide541880-002
2-16
Inventory the Enclosures
Inventory the Enclosures
Verify that the delivered system matches the system you ordered.
To make it easier to verify that all components are in the correct slots and your system
is equipped as ordered, print or photocopy the following information.
Slot Assignments for NonStop S-Series Enclosures
Note. For information about whether SEBs or MSEBs are required for your system, see the
NonStop S-Series Planning and Configuration Guide.
Table 2-1. Illustrations of Enclosures Including Slot Numbers
Enclosure Type Appearance Side Service Side
NonStop S7000 processor
enclosure
Figure 2-13
on
page 2-17
Figure 2-14 on page 2-18
NonStop Sxx000, S7x00, and
S7x00x processor enclosures
(except S7000)
Figure 2-13
on
page 2-17
Figure 2-15 on page 2-19
I/O enclosure without power shelf None Figure 2-16
on page 2-20
I/O enclosure with power shelf None Figure 2-17
on page 2-21
Table 2-2. Slot Assignments: Tetra 8 Topology
Enclosure Hardware Slots Notes
Processor SEBs,
MSEBs
51, 52 Reserve these slots for SEBs and MSEBs.
If ServerNet adapters are in slots 51 and 52, you cannot
attach I/O enclosures to the processor enclosure.
ServerNet
adapters
51, 52,
53, 54
The number of slots that support adapters depends on
the number of enclosures in the system.
If ServerNet adapters are in slots 51 and 52, you cannot
attach I/O enclosures to the processor enclosure.
I/O ServerNet
adapters
51, 52,
53, 54
You can attach I/O enclosures to the processor
enclosures in the Tetra 8 topology without installing
SEBs or MSEBs in slots 53 and 54 of the processor
enclosures.