NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
2-21
Slot Assignments for NonStop S-Series Enclosures
1. Open the appearance-side enclosure door, with a 4 mm (5/32 inch) diagonal
wrench as in Figure 2-18 if necessary. The wrench is provided in the OPEN FIRST
container or taped to the service side of the enclosure.
If you ordered optional service-side doors, this guide assumes that you install them
after you complete the enclosure-cabling tasks in Section 3, Cabling Enclosures.
To install these doors now, see Section 4, Installing Service-Side Doors.
Figure 2-17. Service Side: I/O Enclosure With Power Shelf
DC Power Cable (2 places)
VST972.vsd
55
51 52 53 54
56
X Fabric
Cable Support (1 of 2)
Cable-Routing Channels
Cable Guidepost (1 of 2)
50
Y Fabric
SCSI Port
50 55
Power Interlock
Component
I/O Multifunction
(IOMF) CRU
ServerNet Adapter
Emergency Power-Off
(EPO) Connector
Slot
50, 55
51, 52
53, 54
56
Connects to
Connects to