NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Cabling Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
3-2
1. Connect Power-On Cables
2. Insert the RJ-11 plug on one end of a power-on cable into the RJ-11 jack on the
PMF CRU or IOMF CRU until the tab on the plug clicks into place. See Figure 3-1.
3. Insert the RJ-11 plug on the other end of the power-on cable into the RJ-11 jack on
the PMF CRU or IOMF CRU until the tab on the plug clicks into place.
4. Repeat Step 2 and Step 3 for all power-on cables.
5. With the cable ties, secure the power-on cables for each enclosure to the cable
support.
Figure C-14 Power-On Cables: Four Processor Enclosures, No I/O Enclosures C-8
Figure C-15 Power-On Cables: Four Processor Enclosures, One I/O Enclosure C-8
Figure C-16 Power-On Cables: Four Processor Enclosures, Two I/O Enclosures C-8
Figure C-17 Power-On Cables: Four Processor Enclosures, Three I/O
Enclosures
C-9
Figure C-18 Power-On Cables: Four Processor Enclosures, Four I/O Enclosures C-9
Figure Title Page