NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Contents

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

D. Troubleshooting (continued)

5. Stop All Applications D-28

6. Rename Software Files Using ZPHIRNM D-29

7. Stop System D-29

8. Load System From Saved Configuration D-30

9. Start Applications D-30

System Consoles D-31

Software Configuration Problems D-36

Software Corruption and Hard-Disk Problems D-37

Restoring Software on the Hard Disk D-38

Configuring a ProCurve 24-Port Ethernet Switch D-48

E. FastPath Tasks: Required

1. Install Hardware E-3

1. Inventory Shipment E-4

2. Collect Tools E-6

3. Unpack and Unload Server E-6

4. Connect Groundstraps E-10

5. Inventory and Inspect All Components E-11

6. Connect the Power-On Cables E-11

7. Connect Emergency Power-Off (EPO) Cables E-13

8. Connect ServerNet Cables E-14

9. Install Service-Side Enclosure Doors If Necessary E-15

10. Install Primary System Console E-16

11. Create Emergency Repair Disk or Automated System Recovery Disk E-18

12. Install Ethernet Switch E-18

13. Connect Ethernet Switch to Group 01 E-18

14. Connect Primary System Console to Ethernet Switch E-19

15. Install Tape Drive E-19

2. Start the System E-22

1. Prepare for System Startup E-22

2. Power On External System Devices E-23

3. Connect AC Power Cords E-24

4. Apply Power to Server E-26

5. Verify Topology E-27

6. Verify System Components E-28

7. Start System E-28

3. Verify the System E-30

1. Verify Components E-30