NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing External System Devices
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
7-10
Installing a 519x Cartridge Tape Subsystem
Installing a 519X Tape Subsystem
1. Connect the SCSI cable to the tape subsystem. See Figure 7-8.
a. Open the rear bezel door of the tape module:
1. Pull on the blue-green handle at the top of the door.
2. Lower the door to a horizontal position.
3. Pull up on the spring-loaded plungers to release the hinges.
4. Remove the door from the module.
Find the tape subsystem SCSI cable. For cable lengths and their corresponding part
numbers, see the Part Numbers topic of the Service Information section of the NTL
Support and Service Library.
Figure 7-8. Connecting a SCSI Cable to a 519x Tape Subsystem
SCSI Terminator
on Port
Uncapped
SCSI Port
SCSI
Cable
Rear of 519x Module
VST558.vsd