NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing External System Devices
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
7-11
Installing a 519x Cartridge Tape Subsystem
a. Find the uncapped SCSI port at the rear of the tape drive CRU. The uncapped
port is the SCSI port that does not have a SCSI terminator installed. See
Figure 7-8.
b. Using the SCSI cable connector with the latch-clip flanges, attach the SCSI
cable to the uncapped SCSI port and latch the clips.
c. Route the cable following the instructions in the 5190/5194 Modular Tape
Subsystem Manual.
1. Attach the SCSI cable to the NonStop S-series server. See Attaching a SCSI Tape
Drive to the NonStop S-Series Server on page 7-15.
2. Connect the AC power cord using instructions in the 5190/5194 Modular Tape
Subsystem Manual.
3. Push the AC power switch.