NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Powering On and Starting the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
8-4
Powering On the Tape Subsystem
6. Close the back panel of the 5175 module, pushing at the top to seat the fasteners.
7. At the front of the tape subsystem, ensure that the tape door is closed.
8. On the lower left side of the front panel, press the standby push-button switch to
the ON position.
Powering On a 519x Tape Subsystem
The power-up sequence for the 519x tape subsystem is described in detail in the
5190/5194 Modular Tape Subsystem Manual.
1. Ensure the 519x tape subsystem is installed correctly. See Installing a 519x
Cartridge Tape Subsystem on page 7-8.
2. Ensure that the AC power cord for the 519x tape subsystem is plugged into a
dedicated power receptacle, as indicated on the Floor Plan Diagram.
For every piece of equipment that has two power cords, plug each power cord into
an AC power outlet controlled by a different breaker.
3. Open the rear bezel door of the 519x module by pulling the blue-green handle at
the top. You can lower the door to a horizontal position.
4. Set the AC power switch to the ON position. See Figure 8-2.
Figure 8-1. AC Power Switch for 5175 Tape Drive
AC Power
Switch
AC Power Cord
Rear of 5175 Tape Drive
VST533.vsd