NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Powering On and Starting the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
8-19
Loading the System
3. In the System Startup dialog box, click Start system. The system load begins.
If you want to stop the system startup process, click Abort in the System Startup
dialog box. You might wait up to 30 seconds before the abort takes effect.
Four OutsideView windows, consisting of two startup event stream windows (two
CNSL sessions) and two startup TACL windows (two CLCI sessions), are
automatically launched. It might take a few seconds before the windows appear.
One startup event stream window and one startup TACL window contain system
startup information because they represent the primary ServerNet fabric (X or Y).
The other two windows, which represent the backup ServerNet fabric, are blank.
Figure 8-8. Entering Information in the System Startup Dialog Box
Caution. Do not close the System Startup dialog box while startup is in progress. If you
attempt to close the dialog box, an OSM or TSM message box indicates that the system
startup process will be stopped if you continue. If you stop a system startup before the
operation finishes, the state of your system cannot be predicted. You might need to perform
another system startup to enable the system to resume normal operation.
VST591.vsd