NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Powering On and Starting the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
8-22
Verifying the System Is Started
c. Close the Processor Status dialog box.
2. Verify that the NonStop operating system is working properly:
a. Check the startup TACL window to verify that the startup scripts completed
successfully.
b. Check the startup event stream window and the startup TACL window for error
messages.
3. Close the System Startup dialog box.
For more information on system loads, see:
•
OSM Low-Level Link online help
•
OSM User’s Guide
•
NonStop S-Series Operations Guide
•
Section 1, Introduction
After the system starts successfully, you must perform post-startup tasks such as
testing the system and configuring OSM or TSM. See Section 9, Performing
Post-Startup Tasks.
Figure 8-9. Checking Processor Status
VST008.vsd