NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Performing Post-Startup Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
9-6
Check Critical System Processes
10. In the view pane, click the following enclosure components. Verify that the Power
State attribute for each component has a value of On in OSM or OK in TSM:
•
ServerNet expansion boards (SEBs)
•
Modular ServerNet expansion boards (MSEBs)
•
ServerNet adapters
•
Disk drives
•
Fans
•
Power monitor and control units (PMCUs)
After you click a component, it might take a few seconds for the Power State
attribute to appear in the details pane.
11. In the tree pane, click the system name icon.
12. Repeat Step 5 through Step 11 for each remaining system enclosure in the system.
For the I/O enclosures, verify the status of IOMF CRUs instead of PMF CRUs.
Check Critical System Processes
1. From a TACL prompt, log on to the system using the super ID (255,255). New
systems are shipped without a password for the super ID. For information about
assigning a password, see the Guardian User’s Guide.
> SUPER.SUPER
Password: password
2. Start SCF.
> SCF
3. Enter the LISTDEV command.
-> LISTDEV
Note. IOAM and disk-drive enclosures are powered on when power is applied to the
modular cabinet.