NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Performing Post-Startup Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
9-12
Completing Final Installation Steps
•
The BACKUP and RESTORE utilities test the status of tape drives. See the
Guardian Disk and Tape Utilities Reference Manual.
•
You can use SCF commands to obtain status information about a tape subsystem.
For an example of the SCF STATUS TAPE command, see Check Tape Subsystem
Status on page 9-11.
The SCF STATUS TAPE, DETAIL command produces a report that shows the
processor numbers for the tape process, the logical device number of the tape
drive, and the current state of the tape drive. The following example shows a report
for $TAPE0:
->STATUS TAPE $TAPE0, DETAIL
For more information about SCF commands for tape subsystems, see the SCF
Reference Manual for the Storage Subsystem.
Completing Final Installation Steps
1. Complete any post-installation procedures or special instructions in the Installation
Document Checklist.
2. Perform the required and optional system configuration changes and verifications
listed in Table 9-1.
3. Restart the Inspect Monitor Process.
STORAGE - Detailed Status TAPE \ALM171.$TAPE0
Tape Process Information:
LDev State Primary Backup DeviceStatus
PID PID
51 STARTED 0,273 1,269 ONLINE, BOT
Tape I/O Process Information:
Library File.......
Program File....... $SYSTEM.SYS70.OTPPROCP
Current Settings:
ACL................ INSTALLED Buffer Level...... RECORD
Checksum Mode...... NORMAL I/O *Compression....... OFF
*Density............ 38000 Media Type........ 36-TRACKS
Opens.............. 0 *RecSize........... 2048
Short Write Mode... ALLOWED, PADDED SubType........... 9
Volume Switching.. TRANSPARENT
Media Information:
Automatic Volume Recognition Labels:
VOL1: SANYOA
HDR1: D87D040 SANYOA00010001000100000028 000000000000
HDR2: F080000080000 B