NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Configuring the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
10-2
Setup Configuration
Professional operating system, see the NonStop System Console Guide for Migrating
to Microsoft Windows XP Professional.
Setup Configuration
The setup configuration is a stand-alone LAN used to configure Internet protocol (IP)
addresses. These IP addresses allow a system console to communicate with the
master service processors (MSPs) in the server as shown in Figure 10-1. Actual
connections vary depending upon the Ethernet switch or hub you use.
Procedure to Create the Setup Configuration
On a new server, all these tasks must be performed before you can expand to the
operating configuration:
Figure 10-1. Setup Configuration
Task Instructions Page
Install and cable the server Section 2, Installing Enclosures
Section 3, Cabling Enclosures
2-1
3-1
Install, start, and test the system
console
Section 5, Installing, Starting, and Testing
a System Console
5-1
Install the Ethernet switch or hub Installing the Ethernet Switch or Hub 6-5
Connect the Ethernet switch or hub to
the server
Connect the Ethernet Switch or Hub to the
Server
6-5
Connect the system console to the
Ethernet switch or hub
Connect the System Console to the
Ethernet Switch or Hub
6-6
Start the server Powering On the System 8-5
Configure the OSM or TSM
environment
Configuring the OSM or TSM Environment 9-16
VST992.vsd
System Console
Ethernet
Switch
NonStop
S-Series
Server
Modem
Remote Service
Provider