NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Online Configuration Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
12-12
2. Verify That the Target Disk Is Present
2. Verify That the Target Disk Is Present
Use SCF to verify that the target disk you have chosen is physically present on the
system. In this example, the target disk is $DATA08.
7-> status $data08,detail
STORAGE - Detailed Status DISK \WAGER.$DATA08
Disk Path Information:
LDev Path Status State Substate Primary Backup
PID PID
74 PRIMARY ACTIVE STARTED 2,261
74 BACKUP INACTIVE STARTED 2,261
74 MIRROR ACTIVE STARTED 2,261
74 MIRROR-BACKUP INACTIVE STARTED 2,261
General Disk Information:
Device Type........... 3 Device Subtype........... 42
Primary Drive Type.... 4608-1 Mirror Drive Type........ 4608-1
Physical Record Size.. 4096 Priority................. 220
Library File..........
Program File.......... \WAGER.$SYSTEM.SYS00.TSYSDP2
Protection............ MIRRORED
Hardware Information:
Path Location Power Physical Status
(group,module,slot)
PRIMARY (2,1,17) DUAL PRESENT MIRROR
(2,1,18) DUAL PRESENT
3. Stop Access to the Target Disk and Display Its Status
Use the SCF STOP command to stop access to the target disk.
You can use the SCF STATUS command to check whether access to that disk has
been stopped.
8-> stop $data08
STORAGE W01007 The STOP DISK $DATA08 operation will cause \WAGER.$DATA08
to be INACCESSIBLE to user processes.
Do you want to STOP DISK \WAGER.$DATA08 (Y/[N])y
9-> status $data08
STORAGE - Status DISK \WAGER.$DATA08
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
74 STOPPED STOPPED STOPPED STOPPED 2,262