NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Online Configuration Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
12-14
5. Create a New System Volume and a System
Image Tape (SIT)
5. Create a New System Volume and a System Image Tape (SIT)
Create a new system volume and a system image tape (SIT) for the target disk.
You can create a system volume in either of these ways:
•
Use DSM/SCM to place needed subvolumes on the target disk.
•
Back up the original subvolumes to tape and then restore them to the target disk.
For more information on either of these procedures or the procedure for creating a SIT,
see the DSM/SCM User’s Guide.
6. Install the Boot Millicode on the Target Disk
Use SCF to install the boot millicode on the target disk. In this example, the boot
millicode is installed on $DATA08.
13-> control $data08, replaceboot $system.sys00.sysdisc
STORAGE W01012 The CONTROL DISK, REPLACEBOOT operation will OVERWRITE
the existing bootstrap on $DATA08.
Are you sure you want to REPLACE the bootstrap on $DATA08 (Y/[N])y
STORAGE W01013 To protect you against failure when replacing the bootstrap
file on $DATA08, SCF can place
$DATA08-M in a STOPPED summary state, substate HARDDOWN.
Do you want to abort $DATA08-M (Y/[N])n