NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Online Configuration Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
12-17
Create a Command File
Create a Command File
A command file can automate the task of reconfiguring paths that have been stopped
or deleted. For example, a set of disk drives can be added in one operation rather than
one at a time. The command file must be constructed before the system is prepared to
lose access to the paths.
To prepare a command file that configures a disk drive:
1. Create an editable file by issuing the SCF LOG command:
-> SCF LOG [ logfile-spec [!]]
2. Write to this file by issuing the SCF INFO DISK, OBEYFORM command:
-> INFO DISK $disk-name, OBEYFORM
where $disk-name is a disk to be reconfigured by the command file.
3. Stop writing to this log file by either exiting from SCF or using the SCF LOG
command:
->LOG
-> SCF LOG LOGFILE43
-> info $data3,obeyform
ADD DISK $data3 , &
SENDTO STORAGE , &
BACKUPCPU 3 , &
HIGHPIN ON , &
PRIMARYCPU 2 , &
PROGRAM $SYSTEM.SYSTEM.TSYSDP2 , &
STARTSTATE STARTED, &
PRIMARYDEVICEID 0 , &
PRIMARYLOCATION (2,1,54) , &
PRIMARYSAC 3 , &
BACKUPDEVICEID 0 , &
BACKUPLOCATION (2,1,54) , &
BACKUPSAC 4 , &
AUDITTRAILBUFFER 0 , &
AUTOREVIVE OFF, &
AUTOSTART ON, &
CBPOOLLEN 1000 , &
FSTCACHING OFF , &
FULLCHECKPOINTS ENABLED , &
HALTONERROR 1 , &
LKIDLONGPOOLLEN 8 , &
LKTABLESPACELEN 15 , &
MAXLOCKSPEROCB 5000 , &
MAXLOCKSPERTCB 5000 , &
NUMDISKPROCESSES 4 , &
OSSCACHING ON , &
PROTECTDIRECTORY SERIAL , &
REVIVEBLOCKS 1 , &
REVIVEINTERVAL 100 , &
SERIALWRITES ENABLED
-> log