NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Online Configuration Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
12-18
Create a Command File
4. Edit this log file to create a command file:
•
Remove the top line (the INFO command).
•
Remove the bottom line (the LOG command).
•
Update the locations for any affected adapters (PRIMARYLOCATION and
BACKUPLOCATION).
5. Save this command file for later use.
== STORAGE - Obeyform Information Magnetic DISK \S3.$data3
ADD DISK $data3 , &
SENDTO STORAGE , &
BACKUPCPU 3 , &
HIGHPIN ON , &
PRIMARYCPU 2 , &
PROGRAM $SYSTEM.SYSTEM.TSYSDP2 , &
STARTSTATE STARTED, &
PRIMARYDEVICEID 0 , &
PRIMARYLOCATION (1,1,53) , &
PRIMARYSAC 3 , &
BACKUPDEVICEID 0 , &
BACKUPLOCATION (1,1,53) , &
BACKUPSAC 4 , &
AUDITTRAILBUFFER 0 , &
AUTOREVIVE OFF, &
AUTOSTART ON, &
CBPOOLLEN 1000 , &
FSTCACHING OFF , &
FULLCHECKPOINTS ENABLED , &
HALTONERROR 1 , &
LKIDLONGPOOLLEN 8 , &
LKTABLESPACELEN 15 , &
MAXLOCKSPEROCB 5000 , &
MAXLOCKSPERTCB 5000 , &
NUMDISKPROCESSES 4 , &
OSSCACHING ON , &
PROTECTDIRECTORY SERIAL , &
REVIVEBLOCKS 1 , &
REVIVEINTERVAL 100 , &
SERIALWRITES ENABLED