NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Creating Startup and Shutdown Files
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
13-5
Example Command Files
Example Command Files
This section describes and shows examples of command files that can be used to start
up and shut down the server:
•
Examples and sample programs are for illustration only and might not be suited for
your particular purpose.
HP does not warrant, guarantee, or make any representations regarding the use or
the results of the use of any examples or sample programs in any documentation.
You must verify the applicability of any example or sample program before placing
the software into production use.
•
These examples are for a system whose configuration has been changed from the
factory-installed configuration. Your system’s initial configuration will differ from
these examples.
•
The examples in this section are based on the examples in Appendix 14, Case
Study: Installing and Configuring a System.
The startup files in this section assume that the objects they start have already
been added to the configuration database for the system. For examples of files that
add these objects to the configuration database, see Appendix 14, Case Study:
Installing and Configuring a System.
•
The IP addresses used in this section are examples only. If you use the example
files described in this section on your system, you must change the IP addresses
in these examples to IP addresses that are appropriate for your LAN environment.
•
The configuration track-ID for the SWAN concentrator used in the example files,
X001XX, is also an example.
If you use the example files described in this section on your system, you must
change the configuration track-ID used in these examples to the actual
configuration track-ID assigned to your SWAN concentrator.