NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Creating Startup and Shutdown Files
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
13-11
System Startup File
Comment -- If you have used SCF to start a persistent $ZEXP Expand
Comment -- manager process pair, you do not need an explicit SCP
Comment -- command to start $ZEXP, unless you load the system from a
Comment -- different CONFIG file.
Comment -- If you have not configured $ZEXP as a persistent generic
Comment -- process,remove the commenting from the following SCP
Comment -- command and start $ZEXP as a nonpersistent process pair.
Comment -- OZEXP / NAME $ZEXP, NOWAIT, PRI 180, OUT $ZHOME, CPU 0/1
comment -- Warm start the spooler subsystem using the SPOOLCOM command
comment -- file SPLWARM
OBEY $SYSTEM.STARTUP.SPLWARM
comment -- Start the Transaction Management Facility (TMF) subsystem
comment -- using the TMFCOM command file TMFSTART
TMFCOM / IN $SYSTEM.STARTUP.TMFSTART, OUT $ZHOME /
comment -- Configure and start the TCP/IP stacks on the E4SA ports used
comment -- by the SWAN
OBEY $SYSTEM.STARTUP.IPSTK*
comment -- Start the CP6100 lines on the SWAN
SCF / IN $SYSTEM.STARTUP.STRTCP6, OUT $ZHOME /
comment -- Start the ATP6100 lines on the SWAN
SCF / IN $SYSTEM.STARTUP.STRTATP, OUT $ZHOME /
comment -- Start the X.25 lines on the SWAN
SCF / IN $SYSTEM.STARTUP.STRTX25, OUT $ZHOME /
comment -- Start the printers on the SWAN
SCF / IN $SYSTEM.STARTUP.STRTLP, OUT $ZHOME /
comment -- Start the Expand-over-IP line to \Case2
SCF / IN $SYSTEM.STARTUP.IP2CASE2, OUT $ZHOME /
comment -- Start the direct-connect line
SCF / IN $SYSTEM.STARTUP.STRTLH, OUT $ZHOME /