NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)
Case Study: Installing and Configuring a System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
14-2
About These Examples
About These Examples
Note the following about the examples in this appendix:
•
This case study does not document the factory-installed configuration.
To determine the configuration of your system, see the SCF Configuration File
printout that is shipped with your server for a listing of names and locations of
configured drives. This file can also be found on the ZSYSCONF subvolume under
the name SCF0000. After you have installed and started your system, you can use
SCF to determine the configuration of your system. See the SCF Reference
Manual for G-Series RVUs for more information about this task.
•
The IP addresses used in this appendix are reserved for HP and are only
examples.
If you use files described in this appendix on your system, you must change these
IP addresses to IP addresses that are appropriate for your LAN environment.
•
Names for devices such as tape drives and disks are only examples.
To determine which PMF CRU or IOMF CRU to connect tape drives to on your own
system, you need to know the factory-default configuration of your tape drives. The
configuration track-ID for the SWAN concentrator used in the example files,
X001XX, is also an example. Each SWAN concentrator is uniquely identified by a
configuration track-ID, which is printed on the label on the back of the SWAN
concentrator. This track-ID, which is case-sensitive, is an important part of the
system configuration for the SWAN concentrator. If you use files described in this
appendix on your system, you must change the configuration track-ID to the
configuration track-ID assigned to your SWAN concentrator.