NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)
Case Study: Installing and Configuring a System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
14-4
Hardware Configuration
Hardware Configuration
The hardware configuration for \Case1, the NonStop S7000 system described in this
case study, includes:
•
Two system enclosures, each containing:
°
Two processor multifunction (PMF) CRUs. Each processor has 256 megabytes
(MB) of memory.
°
Two ServerNet expansion boards (SEBs).
°
Two Ethernet 4 ServerNet adapters (E4SAs).
°
Sixteen 4-gigabyte (GB) disk drives.
•
One 5175 open-reel tape drive attached to the PMF CRU in group 01, module 01,
slot 50. This PMF CRU contains processor 0.
•
One 5190 or 5194 cartridge tape drive attached to the PMF CRU in group 01,
module 01, slot 55. This PMF CRU contains processor 1.
•
Primary and backup system consoles attached to a LAN connected to the Ethernet
ports on the PMF CRUs in group 01.
•
One SWAN concentrator. The configuration track-ID for this concentrator is
X001XX.
•
Four Ethernet switches.
Installation Documents
The following figures contain the installation documents needed for the system
described in this case study.
Examples of completed configuration forms and worksheet for the SWAN concentrator
are included in the SWAN Concentrator Installation and Support Guide.