NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Case Study: Installing and Configuring a System

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

14-34

Adding a Direct-Connect Line

This example contains an SCF command file that adds a direct-connect line and a

startup file.

== This is $SYSTEM.STARTUP.ADDLH

ADD PROFILE $zzwan.#pexpsswn, FILE $system.sys00.pexpsswn

ADD DEVICE $zzwan.#Case2elh, CPU 0, ALTCPU 1, RSIZE 12, &

IOPOBJECT $system.sys00.lhobj, TYPE (63,5), PROFILE pexpsswn, &

NEXTSYS 252, ADAPTER s01, CLIP 1, LINE 0, PATH A

== Start the device configured above.

START DEVICE $ZZWAN.#Case2elh

== To enable data communications, you must start the lines using

== the command START LINE $Case2elh or by invoking a startup file that

== contains this command.