NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Introduction
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
1-4
Installation Overview
Section 5, Installing, Starting, and Testing a
System Console
Section 6, Connecting a System Console
The primary system console has a
modem and is configured as a dial-
out point. You must install and
configure this system console
before you can view manuals, start
and test the system, configure the
OSM or TSM environment, or use
the OSM or TSM software.
Do not install the backup system
console until you have started and
tested the server.
6. Install external system devices such as 517x and 519x tape subsystems:
Section 7, Installing External System Devices
7. Power on and start the server with the factory-default configuration.
Section 8, Powering On and Starting the
System
8. Perform post-startup tasks such as testing system components and configuring the
OSM or TSM environment.
Section 9, Performing Post-Startup Tasks
You might also need:
•
SCF Reference Manual for the
Storage Subsystem
•
OSM User’s Guide
•
TSM Configuration Guide
•
TSM Online User Guide
Step Documentation Notes (page 1 of 2)