NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Troubleshooting
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
D-19
Dumping Processor Memory to Disk Online
If a message indicates that the dump was not successful, repeat Step 7 over the
other ServerNet fabric.
If a halt code appears in the Processor Status dialog box for the selected
processor, see the Processor Halt Codes Manual.
10. After the dump finishes successfully, reload the processor by issuing the
RELOAD nn, PRIME command at the TACL prompt.
11. Log off of the OSM or TSM Low-Level Link and the TACL session.
Making a Compressed Disk Copy of a Dump File
1. At the TACL prompt:
> COPYDUMP { $tape | dumpfile }, destfile
where:
2. When the copy operation is complete, this message appears:
{$tape# | dumpfile} HAS BEEN COPIED (COMPRESSED) TO
destfile
$tape name of the tape drive where the tape dump file is located
dumpfile name of the disk dump file specified in the RECEIVEDUMP or RCVDUMP
command
destfile name of the destination disk file