NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Troubleshooting

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

D-29

6. Rename Software Files Using ZPHIRNM

1. Enter the following command using the SYSnn for the software configuration you

are backing out to:

> RUN ZPHIRNM $DSMSCM.SYSnn

The following prompt appears:

Do you want to use a log file with this session? (Y/N)

2. Enter Y. The following prompt appears:

You may use any file for logging. If you request to use a

disk file that doesn’t exist, it will be created as an

entry-sequenced file.

Please enter a filename:

3. Enter a disk file name. The following message appears:

Log file, filename, was successfully created.

ZPHIRNM then renames the applied files. ZPHIRNM issues an EMS event

message when it has successfully finished.

ZPHIRNM must run without errors to complete the software activation. If ZPHIRNM

notifies you of any errors, correct them and run ZPHIRNM again.

7. Stop System

Skip this step if SYSGENR and system load are not required for the revision you are

backing out to and were not required the last time you created a new revision.

1. Shut down any user applications that are still running, such as TMF and

Safeguard.

2. Drain the spooler.

3. Log on to the OSM or TSM Low-Level Link.

4. From the Processor Status dialog box:

a. Select every processor displayed.

b. From the Actions list, select Halt.

c. Click Perform Action.

d. A message appears asking if you want to halt the processor. Click OK.