NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-9
3. Unpack and Unload Server
5. Roll the enclosure or stack off the pallet.
a. Using at least two people, grasp the frame of the stack and slowly roll the
enclosure stack off the pallet, down the ramp, and to the installation area:
6. Move the enclosure stack to its final position. Side frames can touch each other:
7. With a 3/4-inch (19-mm) or a 9/16-inch (15-mm) open-end wrench, lower each leg
on the base enclosure and tighten it against the floor:
8. Repeat the unpacking and unloading tasks for all remaining system enclosures.
Figure E-3. Rolling the Stack to the Installation Area
Figure E-4. Enclosure Stacks in Final Positions
Figure E-5. Lowering Legs of Base Enclosure
vst986.vsd
Group 02
Group 01
VST707.vsd
Group 21
Group 11
VST017.vsd