NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-11

5. Inventory and Inspect All Components

1. In each system enclosure, verify that all components ordered are present.

2. In each system enclosure, inspect the disk drives, PMF CRUs, IOMF CRUs, SEBs

if present, MSEBs if present, and ServerNet adapters.

3. Reseat any CRU that appears to be improperly seated.

6. Connect the Power-On Cables

1. Find the power-on cables included in a box with the system.

2. Find the power-on cable connectors on the service side of each enclosure:

3. Connect the power-on cables according to the appropriate diagram:

Note. The appearance side of the system enclosure is equipped with a door. If neces-

sary, open the door with the 4-mm (5/32-inch) hex wrench that is located in the OPEN

FIRST box or taped to the service side of the enclosure.

Figure E-7. Power-On Cable Connectors

Figure E-8. Power-On Cables: One Processor Enclosure

Figure E-9. Power-On Cables: One Processor Enclosure, One I/O Enclosure

Power-On Cable

VST703.vsd

VST110.vsd

VST111.vsd

0111