NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-14
8. Connect ServerNet Cables
8. Connect ServerNet Cables
If the server consists of only one enclosure, skip to 9. Install Service-Side Enclosure
Doors If Necessary on page E-15.
1. Find the ServerNet cables included with the system. These cables might be any of
the following types:
•
SEB-to-SEB ECL
•
SEB-to-MSEB ECL
•
MSEB-to-MSEB ECL
•
Serial-copper
•
Fiber-optic
Most two-processor or four-processor NonStop S-series systems use ECL cables.
However, if your server is part of a ServerNet cluster, it might be equipped with
other cables. See the NonStop S-Series Planning and Configuration Guide, the
ServerNet Cluster Manual, and the ServerNet Cluster 6780 Planning and
Installation Guide.
2. Connect the ServerNet cables according to the appropriate tables:
Table E-1. ServerNet Cables for One Processor Enclosure, One I/O Enclosure
Attach Cable From Group Slot Connector To Group Slot
01 51 5 11 50
01 52 5 11 55
Table E-2. ServerNet Cables for Two Processor Enclosures, No I/O Enclosures
Attach Cable From Group Slot Connector To Group Slot Connector
01 51 1 02 51 1
01 52 1 02 52 1
Table E-3. ServerNet Cables for Two Processor Enclosures, One I/O Enclosure
Attach Cable From Group Slot Connector To Group Slot Connector
01 51 1 02 51 1
01 52 1 02 52 1
01 51 5 11 50 N.A.
01 52 5 11 55 N.A.