NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-23

2. Power On External System Devices

1. If necessary, power on the system consoles:

a. System unit

b. Display monitor

c. Modem

2. Power on the tape drive:

•

To power on a 5175 tape drive:

a. Make sure the AC power cord is plugged into a dedicated power

receptacle.

b. On the lower left side of the front panel of the tape drive, make sure the

standby push-button switch is in the out (OFF) position.

c. Open the back panel of the 5175 module.

d. At the rear of the tape drive CRU, press the top part of the AC power

switch (“|” on the rocker switch) to apply power to the tape drive.

e. Close the back panel of the 5175 module.

f. On the lower left side of the front panel of the tape drive, press the standby

push-button switch so that it is in the in (ON) position.

•

To power on a 519x tape drive:

a. Make sure the AC power cord is plugged into a dedicated power

receptacle.

b. Open the rear bezel door.

c. At the rear of the tape drive CRU, set the AC power switch to the ON

position to apply power to the tape drive.

d. Close the rear bezel door of the 519x module.

e. If the tape drive includes an automatic cartridge loader (ACL), install the

cleaning cartridge in the ACL.

f. Check the tape drive SCSI ID using the operator buttons on the drive or

ACL front panel. If necessary, reset the SCSI ID with the operator buttons.

•

If your system has another type of tape drive, see the documentation for that

tape drive.