NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-24

3. Connect AC Power Cords

Enclosures Without Power Shelves

1. Find the detachable AC power cords included with your system.

2. Start with the group 01 processor enclosure.

3. Make sure the power interlock on the PMF CRU or IOMF CRU in slot 50 or 55 is

fully engaged so that the power cord retainer is aligned with the power receptacle.

4. Connect the AC power cord to the power receptacle on the PMF CRU or IOMF

CRU.

5. Using a stubby Phillips screwdriver, secure the power cord plug in the power cord

retainer by tightening the retainer screw.

6. Repeat Steps 3 through 5 for the other AC power cord for this enclosure and for all

remaining enclosures without power shelves.

Caution. Do not plug the other end of the AC power cord into the dedicated outlet at this time.

Doing so immediately powers on the PMF CRU or IOMF CRU.

VST708.vsd

Power Cord Retainer

Retainer Screw

Power Receptacle

AC Power Cord

Power Interlock

Ejector