NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-29
7. Start System
The operating system is loaded into the memory of processor 0 or processor 1.
The remaining processors are reloaded by commands in the CIIN file.
6. Monitor the system startup process.
Messages indicating the progress and completion of the system load and the
reload of the processors appear in the following locations on the system console:
•
System Startup dialog box
°
System Status box (initial high-level messages that are not logged to a file)
°
Detailed Status box (low-level messages that you can save to a file)
•
Startup event stream window (startup event stream messages)
•
Startup TACL window (startup messages)
7. When the operating system is loaded successfully into the memory of processor 0
or processor 1, the System Status box on the System Startup dialog box displays:
SYSTEM STARTUP COMPLETE, NSK RUNNING ON Processor n
8. Close the System Startup dialog box.
9. Check processor status:
a. From the toolbar, click Processor Status.
b. Verify that the NonStop operating system is running for all processors.
c. Close the Processor Status dialog box.
10. Log on to the OSM Service Connection or TSM Service Application.
11. In the tree pane, select System Object.
12. In the Attributes tab, verify that the Current Topology in OSM or the Topology
attribute in TSM, has a value of Tetra 8.