NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-32
4. Verify Tape Drive
4. Verify Tape Drive
1. Enter the SCF STATUS TAPE command:
> SCF STATUS TAPE $*
2. Verify that the STATUS TAPE display includes a least one tape drive configured
and running, as shown in the following example. If no tape drive is listed in the
display, call your service provider.
3. Verify the following:
•
The state of the tape drive is STARTED
•
The substate is UP
•
The device status is READY
4. If the state, substate, or status of the tape drive is not as listed here, restart the
tape drive.
5. Verify Firmware
Use the OSM Service Connection or TSM Service Application to verify that all
updatable firmware is at the proper revision level.
For more information, see the OSM User’s Guide or the TSM Online User Guide.
6. Verify State of the Internal ServerNet Fabric
To verify that the paths and connections within the ServerNet system area network
(ServerNet SAN) are properly configured and functional:
1. Log on to the OSM Service Connection or TSM Service Application or.
2. In the tree pane, check for alarms on the Internal ServerNet X and Y Fabric
objects.
3. If an alarm exists:
a. Select the fabric object displaying the alarm.
b. Select the Alarms tab of the details pane.
c. Select the individual alarm.
d. Select Detail.
4. Diagnose and resolve any problems that are causing the alarm. If necessary,
contact your service provider.
STORAGE - Status TAPE $T0150
LDev State Sub State Primary Backup Device Status
PID PID
71 STARTED UP 0,282 1,273 READY