NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-35

2. Configure Kernel-Managed Swap Files

1. Log on to TACL using the super ID (255,255):

> logon super.super

> password: password

2. At the TACL prompt, type NSKCOM.

3. Use the NSKCOM ADD command to create swap files for each processor. For

example:

NSK- ADD SWAPFILE $volume.subvolume.filename, CPU nn, SIZE

nnn MB

4. Start the swap files. For example:

NSK- START SWAPFILE $volume.subvolume.filename

5. Confirm the amount of configured swap space for each processor. For example:

NSK- INFO SWAPFILE *

The minimum recommended file size of the swap file for each processor is

approximately twice the size of the processor memory.

For more information, see the Kernel-Managed Swap Facility (KMSF) Manual.

Note. When naming configured swap files, do not use the naming convention for default

swap files, $SYSTEM.ZSYSSSWAP.SWAPnn.