NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-37

4. Configure System Attributes

4a. Save Current Configuration Database

1. Log on to TACL using the super ID (255,255) and a valid password.

2. List the saved configuration files. At the SCF prompt:

-> FUP INFO $SYSTEM.ZSYSCONF.CONF*

3. Save the current configuration using a unique file name. At the SCF prompt:

-> SAVE CONFIGURATION xx.yy

where xx.yy is a number in the range 0.0 through 99.99.

A display appears in the terminal-emulation window as shown in the following example.

This example saves the fourth minor change to the current system configuration to the

file $SYSTEM.ZSYSCONF.CONF0104.

Caution. On a new system, you must complete these procedures before you run DSM/SCM or

any other program that uses NonStop SQL/MP. Otherwise you might corrupt your SQL

database.

Task Page

4a. Save Current Configuration Database

E-37

4b. Set System Name, Number, and Time E-38

4c. Restart System E-39

4d. Check and Reset System Time If Necessary E-39

4e. Invoke STARTCOM and STARTSCF Startup Files E-40

4f. Reconfigure Processes That Use SNMP E-40

-> SAVE CONFIGURATION 1.4

The configuration file $SYSTEM.ZSYSCONF.CONF0104 has been created.