NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-39
4. Configure System Attributes
4c. Restart System
1. Log on to the OSM or TSM Low-Level Link.
2. In the tool bar, click Processor Status. The Processor Status dialog box appears.
3. Select all processors.
4. From the Processor Actions drop-down menu, select Halt.
5. Click Perform action.
6. In the Processor Status dialog box, monitor the progress of the action. Wait for the
processors to halt before proceeding.
7. From the toolbar, click Start System. The System Startup dialog box appears.
8. In the System Startup dialog box:
a. Type 00 as the number of the SYSnn subvolume containing the system image
to be loaded.
b. Select Current as configuration file.
c. Ensure that the CIIN disabled option has no check mark in the checkbox.
9. Click Start system.
Four windows are launched: two startup event stream and two startup TACL
windows. It might take a few seconds before the windows open.
10. When the system load is complete, the System Status portion of the System
Startup dialog box displays:
SYSTEM STARTUP COMPLETE, NSK RUNNING ON PROCESSOR n
11. In the toolbar, click Processor Status.
12. Verify that the NonStop Kernel operating system is running for all processors.
13. Close the Processor Status dialog box.
4d. Check and Reset System Time If Necessary
Check the system time, log on to TACL, and reset the system time if the time is wrong:
> SETTIME month day year time
Note. The Start system function automatically resets the processor with the new attributes you
defined. If you do not use the Start system function to reload the processors, you must first halt
the processors, and then reset them by selecting Reset from the Processor Actions menu on
the Processor Status dialog box.