NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required

HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002

E-41

5. Configure DSM/SCM

Perform this procedure before installing any new software (SPRs or SUTs) on your

system.

5a Change System Name Parameter in DSM/SCM Client

1. Double-click the SETUP.EXE file in the DSMSCM program group.

DSM/SCM displays the Setup Logon screen, followed by licensing information and

a series of dialog boxes.

2. Click OK in each dialog box until the dialog box asking for the system name

appears.

3. Type the host system name. Click OK.

SETUP updates the DSMSCM.INI file on your workstation with the information you

entered.

4. A dialog box appears

5. saying that SETUP is finished and asking if you want to start the Planner Interface.

Click No.

6. Close the DSM/SCM program group.

Note. These basic DSM/SCM procedures configure the server as a stand-alone host system.

For more information on these procedures and other DSM/SCM procedures, including

configuring the system as a remote target system, see the DSM/SCM User’s Guide.

Task Page

5a Change System Name Parameter in DSM/SCM Client

E-41

5b. Configure DSM/SCM System Environment E-42

5c. Configure Host Information for Host Database E-43

5d. Configure Target Information for Host’s Logical Target E-44

5e. Restart Inspect Monitor Process E-44