NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-42
5. Configure DSM/SCM
5b. Configure DSM/SCM System Environment
1. Log on to TACL using the super ID (255,255).
2. Start the Transaction Management Facility (TMF) subsystem:
> TMFCOM START TMF
3. Run INITENV from the ZDSMSCM subvolume:
> VOLUME $DSMSCM.ZDSMSCM
> RUN INITENV
INITENV displays a series of questions. Answer them as described in the following
steps.
4. To change the default settings, enter C.
5. INITENV displays the current system name and system number. Indicate that the
information is correct.
This step confirms the system name and system number for DSM/SCM. It does not
change the system name and number. Changing the system name and system
number was performed in 4b. Set System Name, Number, and Time on page E-38.
6. Indicate that the system is a host system.
7. Type the database/Pathway owner user ID if you want to change the default value
from being the super ID.
8. Type the name of a hometerm for DSM/SCM to use.
Note. You can use the Change option only once. An Initialization Build/Apply is not
necessary when you use the Change option. However, if you change the system name
and number again, you must use the Reinitialize option to reinitialize DSM/SCM, and then
perform an Initialization Build/Apply before you can use DSM/SCM to manage software