NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-43
5. Configure DSM/SCM
5c. Configure Host Information for Host Database
1. Run ZPHIHMI from the ZDSMSCM subvolume:
> VOLUME $DSMSCM.ZDSMSCM
> RUN STARTSCM
> RUN ZPHIHMI
2. Log on to the host Maintenance Interface using the super ID.
3. Add planners and their security as follows:
a. In the Maintenance Interface main menu, select 3 (Security Maintenance
Menu). Press F1.
b. In the Security Maintenance Menu, select 1 (Planner Security Maintenance).
Press F1.
c. In the Planner Security Maintenance screen, add the appropriate planners as
instructed by the interface, specifying which DSM/SCM tasks each planner can
perform.
d. When all planners are added, press F16 twice to return to the main menu.
4. Modify the Configuration Manager Profile:
a. In the main menu, select 7 (Configuration Manager Profile Maintenance) and
press F1.
b. In the Configuration Manager Profile Maintenance screen, review the
information, and change the default values if necessary.
c. Press Shift-F2 to enter changes. Press F16 to return to the main menu.
5. Press Shift-F16 to exit the host Maintenance Interface.
Note. The super ID is already set up as a planner.
Note. If necessary, use the SCF command LISTDEV TYPE 4 or SCF NAMES
$ZZSTO, SUB TAPE to determine the name of the tape drive connected to the
system.