NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
E-46
5. Install the Backup System Console
14. Connect an Ethernet cable from the cascade port of switch 1 to a port on switch 2,
as shown following. Do not use the cascade port on switch 2.
15. Disconnect the cable between switch 1and the Ethernet port on the PMF CRU in
slot 55, group 01.
16. Connect the cable between switch 2 and the Ethernet port on the PMF CRU in slot
55, group 01 as shown:
17. Perform 3. Configure OSM or TSM Environment on page E-36.
Note. The connections shown are only examples. Actual connections might vary.
Figure E-17. Adding a System Console to the Operating Configuration
Note. The backup system console might display the following message: Unable to
establish a TCP/IP connection to:0.0.0.0 23. To fix this problem, do not modify
the default parameter file TDMTSM.PRM. See the TSM Low-Level Link online help.
VST537.vsd
Cascade
Port
Medium-Dependent
Interface (MDI) Switch
settings for
Ethernet switches
Ethernet Switch 1 Ethernet Switch 2
To Backup
System Console
To Primary
System
Console
Cascade
Port
PMF CRU
containing
Processor 1
PMF CRU
containing
Processor 0
Group 01
MDI
to
Ethernet
Switch
MDI-X
to PC